Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I am searching for a Cisco switch that provide layer 3 features for a local network. Currently i use a 3560 8 ports model and I need something with the same characteristics but having all ports as Gigabit ports.Thanks for helping !Cheers !
Hello,I know that a 1552 AP has 4 Ethernet ports. Does anyone know if is possible to use them as some standard switch ports? If I connect two ore more devices to these ports do i have connectivity between them?Thank you,Andrei
Hello,I want to perform some tests in order to demonstrate that QoS really works. The main test ideas are listed above. The switches are 3560 series, the bridges are 1310 and the IP camera will be a non Cisco one. I will use iperf to generate traffic...
Hi all,I've tried to test the backhaul throughput using a mesh network consisting of two 1552 APs operating on channel 100. For this I've used iperf to simulate a transmission between one laptop connected to AP10 and a server connected to the same sw...
Hello,I'm trying to convert an 1262 AP from LWAPP to Autonomous mode, but the commands above are working just for the conversion from Autonomous to LWAPP. I can't issue the debug command, the archive command, I can't even get into the config mode.Be...
I found the 3560-x series, but they don't offer a model with only 8 ports. Another option is the 3560-C family with the 3560CG-8PC-S refference, but for this one i'm not sure if it offers the same features as the old 3560 version that i currently hav...
I didn't tried to disable my wireless NIC because, until now, I was almost sure that the signal was caused by the AP. The TX power level was set to 1 and the attenuators which I've used had a 20 dB attenuation. I will try to reload the test mayb...
It was a lab setup so both AP were placed in the same room (around 3m between them) and the spectrum analyzer was running on the laptop connected to the MAP via GB port (the 2.4 radio was down). During these tests I also want to observe some th...
