Hello experts, I have a few Cisco 3750G-12S-S 12 port switches that are running on dual power supply. One is AC power and other is DC connected through Cisco RPS 2300. I'm using Cisco Prime LMS 4.2.1 as the Network Monitoring Tool. I get AC power failure alarms from 3750 switches, but I dont receive any DC power failure alarms on Cisco Prime. However, I do receive AC and DC power failure alarms from all other switch models that I have (Cisco 2960G, Cisco 3750x, etc). I also see these alarms in the buffer log of individual switches as well as in Syslog. I'm pretty confident that I've configured the switches with necessary SNMP settings ( snmp-server enable traps envmon ). I've already uploaded the CISCO-ENVMON-MIB file onto Cisco Prime, and only after doing that, I started receiving DC power failure alarms from other switch models. My question is, is the Cisco 3750G-12S-S model supported under Cisco Prime LMS 4.2.1 for receiving DC power failure alarms from Cisco RPS 2300? If yes, is there any additional configuration to be done on Cisco Prime LMS 4.2.1 that I have missed? Any help in this regard is appreciated. Regards, Jayesh ... View more

Hello experts, I'm monitoring 2 ASA 5585-x firewalls (in HA mode) using Cisco Prime LMS 4.2.1. The LMS server is connected to the firewalls on the inside interface. My issue is that I keep on receiving Alert messages on Fault Monitor for both ASA firewalls listing all interfaces (except inside interface) as unresponsive. My thought is that since the LMS server is not able to ping other active interfaces, it generates these alert messages. My query is whether I'm thinking right? If yes, how can I prevent these unwanted messages from showing in Fault Monitor? If I'm wrong, please help me understand. Everything else is working fine without any problems. Thanks, Jayesh ... View more

Hi. I have a new installation of LMS on Windows 2008 R2. I'm having a hard time configuring syslog. When I check the syslog.log file, I see all logs from the switches. My concern is, none of the events are showing up in the Monitoring dashboard. Is there anything specific I have to do so that I see the messages on the dashboard? I dont see even a single entry Syslog Alerts section of the dashboard. Have anyone of you faced this issue before? Is this a software bug or am I missing something. The installation went very well without any errors and antivirus was disabled during the isntallation and configuration. Any help would be appreciated. Thanks, Jayesh ... View more

Hello experts. I have a Cisco 6509-E chassis with 2 ethernet modules, 2 fiber modules and 2 supervisor engines. I lose the configuration of any modules that I remove from the 6509 chassis and insert them back again, excluding the Active Superviror Engine. Is this the default behaviour or I'm missing something? Has anyone experienced this before? What should I do to avoid this? Any recommendation would be greatly appreciated. Thanks, Jayesh ... View more