Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello - My current network is running numerous WS-C2960G-24/48TC-L switches trunked to a WS-C3560G-24TS-S managing VLAN's, default gateway ect... I am looking to purchase more of the 2960 series switches due to recent additions, the 2960G series was ...
Hello,I am having an issue with some users trying to login to our SSL VPN (Anyconnect) via ASA5505 8.2(1). Authentication is done via AD. From the same computer, the client finds the DNS name and unlocks the login username and password. When I ent...
Hello,I'm sorry, this is a noob question. I have 2960G Switches that I would like to change the SSH login password. I was able to figure out how to change the enable password. I tried the following from a DOC I found:Switch>enablePassword:Switch# ...
Hello,I have an RVS4000 located at my office. A user of mine also has one at their house. We have created an IPSec Tunnel between the 2 of them and have them successfully communicating between the 2 networks with no problem.The problem I have is if...
Hello,Our company has an IPSec VPN Setup on a Cisco ASA 5505. We previously were using the Cisco VPN Client - Version 5.0.07.0410. Everything worked fine with this client up until now. The problem is it is not supported in our Virtual Machine envi...
Hello Alain,Unfortunately I never did find a fix for it. I just stopped using it. I would suggest seeing if there is new firmware out you could install that has the fix. Sorry .-Rich
When I run no password and then local login on vty 0 15 I get the same error:Switch (config-line)#login local ^% Invalid input detected at '^' marker.The options I seem to have:Switch (config-line)#login ? authenti...
Thank you very much for your reply - much appreciated. I tried your suggestion and still got some errors kicked back:Switch>enablePassword:Switch#config tEnter configuration commands, one per line. End with CNTL/Z.Switch(config)#line vty 0 15Switch...
Perfect - thank you and sorry for my incorrect naming of the update. In the meantime I will take a look at the release notes. Thanks again Herbert.Regards,Rich Viola
Thank you for the reply Herbert. I guess there is nothing I can do until it's supported and do not need to keep spinning my wheels on it .Will 8.4 be a firmware update?Thanks again. Much appreciated!!Regards,Rich Viola
