Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is my first exposure to DROP and INSERT configs. Same T1. Voice and data. VWIC-2MFT-T1-DI module.Looks too simple. One T1 controller to the service provider, the other T1 controller to the PBX. Cross-connected with the "connect" command.Am ...
I'm trying to integrate a PIX 501 behind a Roadrunner cable modem. I'm not able to ping the default gateway address that I receive from Time-Warner's DHCP server. (I have link lights on both the PIX and the cable modem, and in fact, do receive IP c...
Has anyone seen a scenario that Windows 95/98 clients will not connect, then an hour later, CAN connect?? The opposite is also true: 95/98 clients that can't connect, and an hour later can?clear xlateclear arpreloadThese are the ones I know about. ...
Thanks, Chinh......I had an additional wrinkle...the channel-group command on the PSTN side to define the data timeslots......I can't wait to give this a try...thanks again.DOUG
The config is interesting but I'm trying to understand the relationship of the DS0 group, the TDM-GROUP, and the Channel-group. On Cont T10/0, why a DS0 group and not TDM group?On Cont T10/1, why is the ds0 group of cont 0/0 now a tdm-group?Accordin...
I am also on a quest to get the latest Cisco stencils, if they exist. I have searched all over Microsoft's website, but no luck.Do you know where I can find the latest router/switch icons? I would be a big help. Thanks in advance.Doug Porter
I had a similar experience. The ARP table didn't update as quickly as I'd hoped. What I did was make the ARP refresh parameter as 60 sec. My thinking was that the PIX would constantly update its arp cache. The network could stand the minimal bac...
