Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I'm trying to find solution for mobile vehicle. The base wifi system is lwapp with controller and AP.I was thinking to make bridge between LWAPP AP's and Autonomous AP on the mobile vehicle with client behind the AP, but now the vehicle will h...
Hi All,I install WLC to provide Wlan architecture and the project was extended for VoWLAN. we have 7921 and E51 running over the wide WLAN architecture.Computer using Data over wirless are working over PEAP done by ACS and CA signed certificate + use...
Hi all,I'm using the RME 2.6 of LMs ciscoworks and I want to use a PC/worksattion (Linux, windows) with TFTP/FTP server as remote staging. It is possible to declare a server in the RME devices management like a router/switch with (net-snmp soft) and ...
Hi all,I try to set up multiple Vlan but my issue is to associate them ip subneting.This is the example:I want to make some Vlans:- 1 for Data- 1 for Voiceso I make the ssiddot11 ssid data vlan 100 authentication ...!dot11 ssid voice vlan 200 ...
Hi,This is the second time I post for that kind of issue:the baseline template is really powerful for massive change but limited with acl.I mean ACL is really the kind of things which is helpful to modify in mass but as soon as we just add acd line c...
So I worked to find what was going wrong with Bridge an routing. And I find the issue, now all work fine I can have a subnet over each ssidThanks againMatt
Okay, In fact I'm scared I have not be very clear.I used to use a lot Remote staging but there is some place where I have a lots of 3750series and 2800series which can not be stage, this is why I'm asking you if I can put tftp over a PC and find a wa...
Hi all,first thanks very much for all your answer, I'm pretty busy and I keep that for some of my dead time.I will test all of that and let you know the resultthanks again
yep,that is not realy good in fact.Here is what I will do, I will use the NetConfig to change the access-list.the only way to not destroy the access list is to access them via the conf tand ip access-list Standard (or Extend) 1after that you are able...
