Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I created several Default device profiles and for each subscribed to extension mobility services. I configured my CCM to auto-register phones. Should the Extension mobility service show up? What am I forgetting?
I'm migrating a site that has over 150 speed dials configured. Does anyone have any suggestions? I don't believe I'm going to be able to due this using speed dials since the limit appears to be 99. I was thinking that translation patterns maybe my...
I have a webserver to receives traffic on port 4080. The firewall is configured for this only. I want to redirect traffic to say port 8080. Is there a way to do this on the CSS? I've looked at SSL redirect examples and this requires that I open t...
I'm new to configuring CSS. I have been able to do simple load balancing, redirects and SSL, but I cant' seem to get all three to work together. I have looked at all the docs I can find on Cisco's site, but I haven't found any good examples. What...
I'm a little confused with most of the documentation I found on the Cisco website. In some documentation, they should if you are going from inside to dmz, then use Static (inside, dmz) 172.18.1.0 172.18.1.0 netmask 255.255.255.0In other docs, use NA...
I saw this document, but I thought there was a way to have auto-reg used device default profiles. If this was the case, then it should also include the subscribed service. From you email, this doesn't appear to the be the case. Thanks
I'm running into the same issue with a device. I'm not sure if it's a cabling issue or not. The switch is reporting no errors. Does anyone know how to adjust the keepalive timeout? Tx
I wouldn't turn CDP off. I believe it is needed. I ran into this issue myself and discovered that in some cases, hard setting the switch/phone causes and issue. Set the phone/switch to auto/auto and the phone should connect at 100/full with no err...