Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to figure out where I've gone wrong. I am able to get the FlexVPN tunnel up and running (I can ping the hub loopback from the spoke, and the spoke's assigned address to the VPN tunnel), but I cannot ping/reach the LAN networks of the othe...
I am looking at purchasing a Catalyst switch, either a 3750X or 3850 multi-gigabit model, and my question is this, how do I configure 2 ports to be plugged into the same 3rd party (such as Ruckus) access point so that it works properly? I assume its ...
I would think this should be a pretty easy one for the gurus on here. I need to figure out how to restrict a NAT rule to a specific set of external IP addresses (say for example 8.8.8.0/24). I currently have the following NAT configuration set up to ...
I am experiencing packet loss when pinging a device from the hub router (10.0.0.1 - Network IP, 10.255.255.254) to a device that is behind a remote spoke router (10.0.4.21 - basically any device on that network excluding the remote gateway IP), howev...
A bit of background. I have a network that I need to restrict access to from another network that is on the same VLAN.192.168.0.0/24 <- Restricted Network10.10.10.0/24 <- Secure NetworkI want to prevent 192.168.0.0/24 from being able to access the 10...
Ok, so I have built out the ACL and applied it, but it still allows access from anywhere, even though it is set to only allow access from a single IP for now (testing purposes). I have tried applying the access group on the WAN interface in both inbo...
@Deepak Kumar wrote:Hi,Configure a Standard access-list and define on the WAN interface on INBOUND direction as IP access-list standard 991 deny host 8.8.8.8100 permit any!interface fastethernet 0/1description "Connected-to-WAN"ip access-group 99 in...
Ok, I didn't explain things very well. This is a router that I have as my NAT firewall/DMVPN to the office at my house. What I am doing, if you see the static DHCP assignments for the 192.168 net, those are my daughters iPads. I want to prevent those...
