Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
by default the audio output is set to Loudspeaker that includes incoming call notification and DTMF audio. The issue is that both of those audio levels are too high but being in the call sounds fine. We have looked through the Web Interface for setti...
by default the audio output is set to Loudspeaker that includes incoming call notification and DTMF audio. The issue is that both of those audio levels are too high but being in the call sounds fine. We have looked through the Web Interface for setti...
Using AMX Netlinx with a Cisco Pro Codec firmware 11.20 or higher via RS232 @ 115200 baud rate. The issue is AMX system not receiving incoming call data to trigger a popup page to allow user to answer call. This has happened across several system wit...
Using a Cisco Pro Codec with 11.20 or higher we lose RS232 strings being received for Incoming Calls and DMTF tones don't work as well.Here is what we have changed in the past to get issues resolved but recently these issues are showing up again.1. C...
We resolved by setting output from Loudspeaker to Lineout then back to Loudspeaker. Best guess is that default values behind the scene were being adjusted when switching. Never got any assistance from Cisco nor any reply's on a solution.
