About Istvan_Rabai

Istvan_Rabai · 11-29-2013

My mistake, sorry.Thank you for the correction.The corrected post:In step 3:The router will prefer the paths originated by the local router in the following order of preference:The path was generated by:1. default-information originate command2. netw...

Istvan_Rabai · 11-13-2009

Hi Rupesh,The "ntp master 7" command on Switch-B will set its stratum number to 7, then Switch-A's stratum number will be 8.Cheers:Istvan

Istvan_Rabai · 11-13-2009

Hi Rupesh,I have the understanding that the NTP configurations are already in place.In this case you could enable "ip nbar protocol-discovery" on the interfaces where you are interested about bandwidth consumption.The "show ip nbar protocol-discovery...

Istvan_Rabai · 10-05-2009

As to BGP for IPv6, it is there, but under a different name:Multiprotocol BGP (MP-BGP), which is used to carry IPv6, Multicast and VPNv4 updates among others.Cheers:Istvan

Istvan_Rabai · 09-30-2009

As there's not enough room for explanations here, I would suggest you to read the configuration examples from Sam Halabi's Internet Routing Architectures:http://www.ciscopress.com/bookstore/product.asp?isbn=157870233XCheers:Istvan

Member Since	‎01-05-2007 11:55 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	789
Total Helpful Votes Received	561

User Statistics

User Activity

Re: BGP path selection with 3 & 5th step

Re: Stratum on NTP

Re: Bandwidth used by NTP traffic

Re: IPV6 and Frame Relay

Re: BGP multihome with two isp's