Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have two switch.Switch 1 is a standalone switch with two TenGig ports as 1 port-channel (ports ten1/1/1 and ten1/1/8). Switch 2 is a stacked switch with two TenGig port as 1 port-channel (ports ten1/1/1 and ten2/1/1).When I run show xfsu eli...
Hi all,Cisco DNA Center Ver 2.3.7.109300 switches Ver 17.15.04 (upgrading to IOS 17.15.05)I am trying to figure out how to activate xFSU when upgrading a switch's IOS image through DNA Center's SWIM process.From my understanding, our current version ...
Hi all,I am new to CUCM so bear with me.We had a 3rd party vender called into our office and our department did not pick up the call due to the caller ID displaying Toll-Free.In CUCM, I there a way that I can manipulate an external inbound caller's c...
Switch> show spanning-tree vlan 402 detailVLAN0402 is executing the rstp compatible Spanning Tree protocolBridge Identifier has priority 61440, sysid 402, address 6c03.09b9.4f80Configured hello time 2, max age 20, forward delay 15, transmit hold-coun...
Hi @HtonietoFirst, I want to say, thank you for your time and help with my issue.Just so I understand, I should run the show cdp / lldp neighbors command to see if there is a L2 loop between the two ports that are acting as a port-channel. If there i...
Hi @Maren Mahoney For the CUBE part of your statement: I do know the specific inbound calling party number. do you have documentation or an article on how to perform this change?Thank you for your time and help,
