Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Current setup:WLC 9800-L-F-K9 (Active) → Core Switch (Primary) → Active Gateway → FTD Firewall → Router → ISPWe have purchased another WLC 9800-L-F-K9 and need to configure High Availability (HA) between the two controllers.The new WLC will act as St...
Network scenario: ISP>CISCO Router> CISCO FTD > Core SW >Access SW > Serverwe have two public ip like 203.76.64.16/28 and like 203.76.64.64/26 here only 203.76.64.19 is my end and also 203.76.64.64/26 is used for only one to one NAT in FTD for my few...
Network scenario: WLC 9800 (192.168.110.9) is connected to Core Switch (192.168.110.1). Then From Core Switch > PoE Switch > APs are Connected. but main problem is I couldn't connect to WLC using SSH from any Vlan or SSID and also not getting GUI fro...
our client currently using a cisco AIR-CT5508-K9 wireless controller with 100 Access Points. They want to replace the current setup by using a new wireless controller, Catalyst 9800-L-F, along with 100 new APs AIR-AP1852I-C-K9. Controller is connecte...
I have a client who is currently using a Catalyst 9800-L wireless controller (exact model and version not confirmed yet) with 50 Access Points. They want to replace the current setup by using a new wireless controller, Catalyst 9800-L-F, along with 5...
I will try again and verify whether the logs are generated. Sometimes the logs do not appear because a large amount of information—such as AP and client MAC logs—is received at once.I have another question as well:Is there a way to temporarily suppre...
I’m not getting any error messages, but when I try to connect using PuTTY, the SSH login prompt doesn’t appear. Because of that, I can’t enter the username or password.I’m also having the same issue with the GUI — the page is not loading.Could you pl...
I did not receive any error message. When I attempt to connect via SSH using PuTTY, no prompt appears for entering the username or password. That is the main issue—without the login prompt, I am unable to proceed with authentication.Additionally, I a...
I need to downgrade the software on both SPINE and LEAF switches under the following conditions:SPINE: From version 16.0(8d) to 15.2(7f)LEAF: From version 15.2(8e) to 15.2(7f)Due to the current setup, I can only perform this downgrade via console ac...
