Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I want to configure the SSH session idle timeout on the Cisco Nexus N9K, but I can't find the CLI to configure it. Any expert can share with me the CLI for configuring the SSH session idle timeout. Much AppreciateJordan
Hi,Can I know how to solve this NVT: TCP Timestamps Information Disclosure on the Cisco N9000 as this vulnebility is found out at the VA ScanSummaryThe remote host implements TCP timestamps and therefore allows for computing the uptime.Vulnerability ...
Hi I try to configure the static MAC Address on the Cisco Nexus N9000, but it prompts the error message "Invalid MAC: multicast/broadcast not supported!". Is any expert know why prompt this error message CoreSW01(config)# mac address-table static 03b...
Hi everyone,From what I understand, VRRP group numbers can range from 1 to 255. Can someone confirm if the VLAN interface ID and the VRRP group ID have to match, or can they be different?For example:VLAN Interface: 300IP Address: 10.10.300.1/24VRRP G...
I’m currently migrating from a Cisco Catalyst 3850 Layer 3 core switch to a Cisco Nexus N9K using vPC. On the Catalyst, Interface VLAN 1622 is configured with multiple IP addresses on a single SVI, as shown below:192.9.203.253192.9.209.253 secondary1...
HiSo I can just ignore this config and no need migrated this config from Catalyst 3850 to the Nexus N9K. Please correct if I am wrongBest Regards. Cheers
As I am doing a migration from the Cisco Catalyst 3850, and all these IP addresses are inside the interface VLAN. Hence, from the migration purpose I will copy to the Cisco Nexus N9K as well.
Hi,Yes, on the current single Catalyst switch, VLAN 1622 has multiple IP addresses configured. For the migration to the two Cisco Nexus N9K core switches (core-sw1 and core-sw2), we plan to replicate this setup by assigning multiple IP addresses on e...
I had read thru the design guide vPC Orphan Ports Suspend vPC orphan ports suspend feature was developed for single-attached devices to vPC domain and optionally working in active/standby mode (firewall or load-balancer for instance). When a vPC peer...
