Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am also having a similar problem, currently trying to find out what the cause is. Only affects the VLAN config pull. It does not appear to affect running / startup. Running LMS2.5 with SP1VLAN RUNNING Nov 04 2005 11:18:06 Insufficient no. of int...
Ciscos also have a tool to work out the exact power and heat load based on actual configuration. Also provides the % of capacity utilised on the power supplies units, pretty essential at design phase to ensure the correct PSUs are specified. A must...
It is an IOS issue, the older IOS that came with the 3550s did not support the 1000Base-T GBICS. You will also need to upgrade the IOS on the 2950's. I had exactly the same problem when I started using RG45 GBICS, moving away from Gigastack to impro...
