Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a GLBP config consisting of two Cat4506e switches, connecting over 10G fiber to Cat3560E switches. Testing, I have a laptop connected to one of the 3560 switches with a constant ping to the Virtual IP addresses of the GLBP on two different VLA...
I have Netflow enabled and collecting data on my 5510. My problem is that the interface on the ASA is 100Mbps, and my internect connection is only 4Mpbs. My netflow data show all traffic at 1% or less because of this. Is there a way to fake the ASA i...
I have a VPN set up between an 871 router and an ASA 5505. VPN tunnel is up and I can pass traffic between the LANs. I can hit the phone system from the remote site (behind 871) as well as the main site via VPN tunnel. But, none of the phones will re...
I have a cme router that is utilizing 7 FXO ports in a trunk. See output below:Port 0/1/2 is the main incoming number. The problem is that when a call comes in, it will seize that port, and any additional calls will come in and get a RNA. Anyone have...
Apparently I dont have a clue when it comes to wireless. This was set up before I got involved with this organization. We have a Cisco 850 with a Wirless card, and an Aironet 1200. Each placed at each end of a building. Clients can intermittently con...
Yes, I can (and will) add switchport trunk allowedOn all switches globally I have spanning-tree mode rapid-pvstIs your comment to allow portfast, or not?Thanks for you reply.
Unfortunately, I am not using static NATs for either of the subnets... My Nataccess-list inside_nat0_outbound extended permit ip object-group DM_INLINE_NETWORK_11 192.168.14.0 255.255.255.0The DM_INLINE_NETWORK_11 includes the phone network (10.10.10...
I ran the command on both the router and the WAP and I received no power settings on either. I'm pretty sure that it is the default power settings for both. Was it my notion that I'm totally clueless with Wireless or that I think the 1200 has a stro...
