About jcsm1th

jcsm1th · 03-02-2004

I am working on migrating our Intervoice IVR to CCM for a new contact center we are building. The IVR was previously connected to a Siemans switch but will now be connected to a 6608. The connection between the GW and IVR is T1 CAS using E&M Wink s...

jcsm1th · 03-29-2005

djscott,Did you get anywhere with the 6.0.2SR1 angle? I have read through all the threads in the forum, and this is the only post that seems like it might match my problem.I have, created the png files, created the directories on CM, created (and re...

jcsm1th · 03-09-2004

Yep, that is all you should need. The router will take the packet, add a GRE Header (about 24 bytes I believe) add an IP header and send it on it's way to the destination address using the source IP address of the tunnel source interface.You can use...

jcsm1th · 03-08-2004

Not sure what the specific problems you are having may be related to, but here are the HW and SW requirements for the SA-VAM.HW RequirementsIn the Cisco 7200 series routers, the VAM requires a network processing engine 225 (NPE-225) or above. We reco...

jcsm1th · 03-08-2004

Simon,It appears from the config, that not only do you not have an IP address configured on the router, but it is shutdown as well. The same is true for the ATM interface. Without knowing the exact circumstances around this problem, it could be som...

jcsm1th · 03-08-2004

Assuming this is just from one site to another it should be pretty straight forward. The GRE Tunnel (in this case) will act just like any other interface you would enable IPX on. We had a similiar situation we fixed with Tunnels across our IP only ...

Member Since	‎03-01-2004 07:12 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	8

User Statistics

User Activity

Supress Digits from 6608 GW to legacy IVR

Re: 7970G Creating Custom Background Images

Re: IPX Tunnelling over IP WAN

Re: SA-VAM

Re: Need help Cisco Roter 800A

Re: IPX Tunnelling over IP WAN