Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to enable the DHCP snooping on 4500 switches (SUP6E), is it must to enable the IP source guard or static ip source guard for static ip address in the network?, as I know ip static source guard is not supported on sup6E.Regards
Is it possible to deploy the CSS11501 in one arm design to loadbalance the authentication traffic Radius across CSACS servers which is on UDP 1645 or 1812 port, is it required to configure the NAT or not, if yes how can define the shared secret in th...
Is it possible to configure the CSS11500 as single arm design? if yes how to configure the source nat on the CSS11500, it is not possibe for me to change the default gateway as well as configure CSS as inline.Regards
best way to fwd Layer 2 traffic across layer 3 link whihc is b/w 6500 and 4500 (multiple distribution) switches. while l2 clients directly connected to 4500 and 6500, can say non routed vlans earlier while it was connected at Layer 2 trunk, but now l...
does dhcp snooping required to enable IP Source guard as a must? i read in Cisco document that 4500 SUP6E is not supporting the Static IP source guard at all.
Dear,Please let me know how can I add the class-map generic to multi-match policy and also how to use the existing class-map for virtual address.RegardsFayyaz
I am explaining you step by step1) You need to upgrade the bios first for th IDS 4235 (connect keyboard and Monitor directly to sensor).2) Upgrade the 4235 Sensor with 4.X CD.3) Logon on to Sensor 4235 using name cisco and password cisco.4) Run the s...
