Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am upgrading the software on a NX-1000v. When I run the pre-upgrade utility I pass every check except check #2 (Port-profiles). The output tells me to put the speed and duplex configurations on the Port-Profile and remove them from the interface. H...
I would pick either Switch 1 or Switch 2 to host the VLAN 10 SVI. Then use dot1Q Etherchannel trunks (L2 only) between the switches. I think this would greatly simplify your design. There is no reason for both switches to have a LVAN 10 SVI.Mike
Thanks Michael,I must be going crazy or something??Last week I could have sworn that speed/duplex didn't show up when looked under the port profile attributes. You're right though, there they are!!Thanks,Mike
