Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have read all I can on GLBP without a definitive answer to my question. I have two 7613 routers connected to two 7304's that serve as our gateways to the ISP. I would like to run these connections through a 6509VSS and run GLBP on all 4 rout...
We have command authorization using TACACS currently deployed network wide. We are begining to deploy routers using VRF lite and within 6 months will deploy full MPLS over a metro-wide fiber network. TACACS is currently not supported using VRF instan...
This is a new setup for testing. I have a call manager and 1 phone (phone A) on the same subnet and 1 phone (phone B) on a different subnet which is behind a PIX 510. The call from phone A to phone B completes normally. A call from phone B to phone ...
UPDATE.....Since first posting this question, I have coded the design in a lab and the design works as drawn. This provides gateway protection to an ISP in both directions.
Danne,I searched the feature navigator ( cisco.com/go/fn ) and there are only 3 IOS versions listed, none of which show support for the 3550. I wanted to use a 2651xm and it is not supported by one of these either. I needed the command level authoriz...
Your right, that is the most logical answer: however, in our test environment, the IP VRF command is not present when we configure TACACS+. The following is our testing setup:2651 runing IOS version 12.2.15ZJ51 frame circuit with 2 PVCs2 FastEthernet...
