Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are using Cisco SG550X-24 (fw 2.5.0.83) at our remote office. A firewall report for Top Blocked Clients is showing SG550X-24 at the top with 5,004 hits every 24 hours. When looking at the firewall logs closer we are seeing the same pattern ever...
Hi, Is there a way to stack SG500-28P & SG550X-24 ? It looks like on an SG550X-24 switch I can choose which ports to use for stacking 10G-FiberOptics or 10G-ComboC /10G-ComboF, however on the SG500-28P stacking ports are hard set to 1G/5G ports. An...
Hi,We are looking to at a Cisco Wireless solution for our office. Looking to start with 4 APs and a controller. For the controller we are gonna use a L-AIR-CTVM-5-K9, however not quite sure what APs are compatible with the controller. Do we want APs...
Hi,
Is it possible to set up a site to site VPN between the RV345 and one of the older RV042 or RV016 routers?
We had a tunnel between the RV042 and RV016 routers for quite a long time. Recently RV016 was upgraded to RV345 and we can't seem to ge...
We have two offices located across the hall from each other.
There is a Cisco SG500-28P in each office ( frm: 1.4.7.6) We have 2 cat6 runs between the offices which interconnect the switches (LAG) Every night we push over 50Gb of data from one offi...
I should add that ICMP is a type 13 packet (Timestamp request)Internet Control Message ProtocolType: 13 (Timestamp request)Code: 0Checksum: 0xf0d2 [correct][Checksum Status: Good]Identifier (BE): 557 (0x022d)Identifier (LE): 11522 (0x2d02)Sequence nu...
Yes, we access the switch via the WEB interface, but not every minute. PRTG is pinging the switch every 5 min and switch is sending sFlows to PRTG. Wondering if the switch itself has some kind of keep alive check for the configured default gateway it...
North America. Looks like there is a promo on some of the APs, buy 2 get one free but the part numbers seem to have a typo what I think should be an I (for internal antenna) shows up as 1. https://www.cisco.com/c/dam/en/us/products/collateral/wireles...
