Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i am setting up an ISE for dot1x and posture checking, I am unable to find a way to check for a policy whereby the laptop/workstation is a domain machine. So far, the rules and config guides are looking at ExternalGroups member of, but these are t...
Hi,WLC is running the 4.0.217.203 version. I managed to find Document ID: 96103 but it did not mention the supported WLC version.Do I need to upgrade the WLC ?Regards,Ron
in a 4507 switch, I have 2 units of 4200W working in redundant mode. Each PSU has 2 input of 220V. Call it PSU 1-1, PSU 1-2 for PSU1 and PSU 2-1, PSU 2-2 for PSU 2.When PSU 2-1 input is faulty (power source and cables are fine, confirm is PSU hardwar...
Hi Glenn,Thanks for your reply. It is happening exactly as you mentioned. I tried searching the bug tool kit but no such info is available. Are there any docs that states this ? Is it the same for all Catalyst switches?
Thanks, but I still dont understand why is the switch making the "good" PSU going into err-disabled mode. I am 100% sure that PSU 1 has 2 x 220V input. But the switch is using the PSU2, only 1 x 220 V input. And it put the PSU 1 into err-disabled mod...
