Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am introducing new Cisco C3850 switches into an existing Dell environment. This will be a phased replacement so I have a need to link the 3850's to Dell 8132F's. My 3850's each have a C3850-NM-4-10G network module and the Dell switches have SFP+ po...
I have found information on setting up concentrators for load balancing and have that figured out. I cannot find out any information about how the member devices keep their configurations in sync. Is this automatic or does it required updating all me...
When a VPN Client connection is established the metric for ther VPN routes is set to 1. Is there any way to have these set to follow the metric of the adapter used to establish the VPN connection? For example if I used the 100MB adapter on a system t...
Can someone give me the pros and cons of using these two methods? The environmnt is a VPN3015 and a Windows 2003 Active Directory. What would be the specfic downside of using NT Domain authentication?
I am trying to setup a custom events to email. Here are the entries in my evnet list:ALL/SEV(1-3)AUTH/22,28, SEV(4)The goal is to see all severity 1-3 and the two AUTH events 222 (login) and 28 (disconnect). I have set my events to email to "use even...
I think I answered my first question. Doing a bit more digging I found the "Cisco 10-Gigabit Ethernet Transceiver Modules Compatibility Matrix" which shows the SFP-H10GB-ACU10M is supported on the 3850 with OS XE 3.6.0E installed.Still would like to ...
Hope you have figured this out by now but if not here is my 2 cents worth. I think this is a MTU issue also. When you install the VPN client the MTU of the interfcaes are set from the default to 1350. This is most likely what is happening to fix the ...
You might check to see it the flash needs to be reformted. There is a propblem with the flash on some of the 3005's. See http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps2284/products_field_notice09186a00801fb6bc.shtml for details on the prob...
Have you tried to lower the MTU on the Ethernet adapter on the notebook? I would try 1300 but have seen cases with DSL connections requiring a MTU as low as 1250.
I tried both of those tools and got no hits. I then opened up a case with TAC and found out this is a problem with clients behind Linksys NAT routers. I did some detailed review of my log files and confirmed that each time this happens there is a dum...
