Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
We are currently experiencing an unusual event regarding our infrastructure. On the last couple of months users on a certain switch has been complaining that they are getting disconnected. Tried to check the spanning tree status as w...
Hi Everyone,
We happen to purchase a DATA K9 license online and we happen to receive it now via eDelivery. When i checked the contents on cisco website, i only found the PAK/Token ID. Any advise on how can i proceed to install it on our 1921 routers...
Hi,
We are in the process of considering deploying ACI. Would like to seek help with you guys on how can i start on the network side? I have checked all the documents and it seems they are discussing once the network has been set-up. I am looking fo...
Hi Everyone,
I am having a hard time understanding DLSw. Is there anyone who can help me and give me atleast a basic understanding of how this technology works?
I am browsing the internet and the answers that i receive are way too technical as of t...
Hi,
I just recently deployed a couple of Cisco Catalyst 3850. Those switches are purely Layer 2 only.
I have configured an interface vlan on each and every switch to serve as its management IP Address. I have used both ip default-gateway command an...
Hi gpauwen,
Thank you for taking a look on my question. I checked the logs but as far as logs are concern i dont see anything pertaining to the stack membership being lost or stack ports going down.
Thank you
Hi,
Just a quick follow-up question.
Does the Ethernet 0 or the interface where the bridge-group command is configured needs to be route-able through out the entire network? or the only important thing to be routed is the loopback interface which i...
Hi,
Just a quick follow-up question.
Does the Ethernet 0 or the interface where the bridge-group command is configured needs to be route-able through out the entire network? or the only important thing to be routed is the loopback interface which i...
Hi,
Just a quick follow-up question.
Does the Ethernet 0 or the interface where the bridge-group command is configured needs to be route-able through out the entire network? or the only important thing to be routed is the loopback interface which i...
Hi Tomas,
Thank you for sharing the links. Honestly, i have not get the chance to talk with our cisco account team. I am planning to have some due diligence to have atleast a basic understanding with the technology in order to ask the right kind of ...
