Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, anybody know of any good self study materials for the 642-582 WLANFE exam? I'm CCNP and have considered the following book.802.11 Wireless LAN Fundamentals By Pejman Roshan, Jonathan Leary. Published by Cisco Press. ISBN: 1587050773Is this enoug...
Hi,I have run some subjective audio tests between an ATA and and E&M card in a 3745 router and found problems end to end. ATA to ATA and E&M to E&M perform perfectly. We have narrowed the problem down in a lab by having a single ethernet crossover b...
Hi,I have run some subjective audio tests between an ATA and and E&M card in a 3745 router and found problems end to end. ATA to ATA and E&M to E&M perform perfectly. We have narrowed the problem down in a lab by having a single ethernet crossover b...
I have upgraded a number of ATA188's from MGCP to H323. This part was succesful. I have also created induvidual configs on the tftp server for each device. On a few of the config files I made some typo's on the UID, I used duplicated numbers! I ha...
Hi,I have a router which dials a central site with 2 ISDN lines (4 B channels). If the highest interface (BRI 1/1) becomes disconnected/faulty the other wont connect at all.When the two lines are plugged in and working OK I notice that the dialer sta...
Hi,Looks like I phrased it wrong "GapFillWithPrediction=180 ms" is the actual term. But i guess this is only the result of the out of sequence or lost packets. The network cannot be at fault as there is a crossover cable directly between the two de...
Hi,We are seeing the predicted seconds increase on the E&M card using the "sh call activ voice" command. All usul Fastethernet interface stats look ok.Will have to try the sho voice call xxx later this week as I'm not near the lab todaySee attached "...
Hi, thanks for the reply. I haven't got the unit/config file with me at present to check the settings. I am confident that the reset/refresh works OK as the unit does do a re-boot after applying this command. LED start to flash etc just like the nor...
