Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How should tunnel-group-lock be configured on a Cisco ASA when managed by Cisco FMC?For example, assume there are two users in the local database: user1 and user2.Each user has a different group policy assigned.However, when user2 connects to the VPN...
How can I change the management IP address, subnet, or gateway for a Cisco Firepower Threat Defense (FTD) device managed by Firepower Device Manager (FDM) in a High Availability (HA) pair? (step by step guide) (active and passwive device steps)
“There is a Catalyst 1300 Series switch. Voice VLAN is 211 and Data VLAN is 200.On port Gi1/0/10, there is ‘switchport mode access’ and ‘switchport access vlan’, but there is no ‘switchport voice vlan’ command.This port is connected to a Cisco IP ph...
“In Cisco FMC, under Analysis > Connections > Events, no logs appear for Remote Access VPN (SSL VPN) sessions. All hit counts for users connected via Remote Access VPN show ‘0’. However, when I create a rule for Remote Access VPN under the policy sec...
There are 2 FTDs connected to the FMC and under HA.I want to change their management IP addresses. How do I do this step by step?FMC IP 10.12.200.28/24FTD 1 IP 10.12.200.11/24FTD 2 IP 10.12.200.12/24These FTDs are connected to HA on FMC.I want to mov...
No . this steps not helpfulI followed the procedure described here and began with the standby unit. However, during this process, access to FDM was lost on both the active and standby devices. Restoring the standby unit to its previous IP address res...
For example :active FTD Device mgmt ip address: 10.11.0.101/24standbye FTD Device mgmt ip address: 10.11.0.102/24I want to change active mgmt: 10.0.0.10/24 and standbye mgmt:10.0.0.11/24
