Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have Cisco ASA in "active-active" clusters , if there is a change of roles from master to slave (or vice versa) on any member of the cluster, there is a chance that the NAT pool ownership may not get transferred in the process. As a result, the ne...
Few devices do not let us run any command after we log in we get an error stating
"% Authorization failed."
Note -
We have resilient ACS server 5.8. This is happening on only a few routers which is a mix of Cisco 891, 1941 and 3925. No pattern is...
I have a client who has been using Meraki MR18 and MR34 Access point with Cisco Meraki controller for guest traffic .
1) I want to know if MR 18 and MR 34 are compatible with Cisco WLC 5508 .
2) Can a AP have two controller . Need here is to have 1 ...
All shell profiles have a privilege level of 15. The command set is ruling who gets read-only access and who get read-write.
Also to emphasize other devices sitting in same rules and same shell profile works perfectly.
It is indeed authenticating via tacacs credential only and does not accept local credentials. Only way I can make them work is by removing their IP from ACS server, hence, enforcing access by local accounts then I need to remove dual ACS configuratio...
It is indeed authenticating via tacacs credential only and does not accept local credentials.
Only way I can make them work is by removing their IP from ACS server, hence, enforcing access by local accounts then I need to remove dual ACS configurat...
