Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hellowe are preparing migration for a customer, from ACS 5.8 to ISE and want to use migration utility; this utility require to enable migration interface using command acs config-web-interface migration enable on ACS CLI.Unfortunately access to CLI (...
Hello i am puzzled with situation where lots of WAPs are trying to reach to destination IP address 13.13.13.13 via udp/5246 port.We have on prem WLC that has no traces of these WAPs; Prime Infrastructure shows info about only one access point in its ...
HelloI am looking for a support matrix for following WAP/WLC combos. Is there any document i can use to make a support matrix like this? We are planning to upgrade to the C9800-80 and need to know which WAPs i can reuse and which i have to replace. I...
Helloit must be the way to rename authentication rule names but i cannot find it. I can alter the rule itself, duplicate, delete, set to disable or monitor but for some reason i cannot find the way to rename it.. So all my policies are Authentication...
Hello
is it possible to configure ports on CISCO891-K9 for port-security? i need to use mac address port-security on few switch ports but "switchport port-security" command is not available.
I am running following:
Cisco IOS Software, C890 Softwar...
Thanks Damien for quick respond. What i actual done is: cloned the production ACS VM; disabled the network interfaces; added CD, boot off CD and changed admin password; reloaded cloned ACS and attempted to login to ACS. The login was unsuccessful wit...
Thanks for your reply; i am guessing you need to login with admin un/pw in order to change default value, but as i mentioned i am unable to login after successfully reset admin password, due to number of failure login attempts. Any other suggestions...
Thanks DamienI did went thru password reset process but unfortunately i cannot log in with admin un/pw, pls see attached...The same thing is happening on my second ACS (standby). Is there any way to prevent lockouts using GUI?
Thank you guys for all your suggestions; i will get the console access to see what is going on as well will do the option 43 for testing.Will post updates shortly. Thanks again
I can see traces in Prime Infrastructure of only one AP. Cannot see others We are not using option 43 for WLC discovery, just DNS.It is weird that just some numbers of WAPs are causing this behavior and none of these listed IPs are reachable at this ...
