Moreplovac
Level 1
Level 1
Member since ‎05-11-2016
‎03-09-2020

User Statistics

  • 26 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Discussion Posts
20 Discussion Posts
First Discussion
First Question
10 Discussion Posts
1 Reply
10 Replies
5 Replies

User Activity

Hellowe are preparing migration for a customer, from ACS 5.8 to ISE and want to use migration utility; this utility require to enable migration interface using command acs config-web-interface migration enable on ACS CLI.Unfortunately access to CLI (...
Hello i am puzzled with situation where lots of WAPs are trying to reach to destination IP address 13.13.13.13 via udp/5246 port.We have on prem WLC that has no traces of these WAPs; Prime Infrastructure shows info about only one access point in its ...
HelloI am looking for a support matrix for following WAP/WLC combos. Is there any document i can use to make a support matrix like this? We are planning to upgrade to the C9800-80 and need to know which WAPs i can reuse and which i have to replace. I...
Helloit must be the way to rename authentication rule names but i cannot find it. I can alter the rule itself, duplicate, delete, set to disable or monitor but for some reason i cannot find the way to rename it.. So all my policies are Authentication...
Hello  is it possible to configure ports on  CISCO891-K9 for port-security? i need to use mac address port-security on few switch ports but "switchport port-security" command is not available.  I am running following: Cisco IOS Software, C890 Softwar...
Community Statistics
Member Since ‎05-11-2016 02:06 PM
Date Last Visited ‎03-09-2020 08:59 AM
Posts 26