Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello ,Our Company is planning to refresh Cisco infrastructure . The infrastructure consists of 6500 with EoL SUP and edge 3750 and completely routed network. I am confused with the future selection in terms of Nexus and 6500 as we are planning for...
i am trying to access management interface of a layer 3 device using OSPF but getting some problem on that. Can any one help to resolve.Please see the attached diagram, Here is the config of interestR0:Its a multilayer switch. Interface e0/0 is route...
we are using ipsec tunnel between two companies. Company A uses core of its serverices in the ip range 10.0.x.x to 10.95.x.x network . A assigned 10.96.x.x to 10.127.x.x network for B. B is using 10.96.x.x to 10.127.x.x for its core network and also ...
Can any one help me in identifying this issue. I have four core switches two in A side and two in B side. A side running with Ciso IOSpvstlayer 3 and layer 2 switcheB side running with CatOSPVST+layer 3 and layer 2 switchesIn q site suddenly the whol...
Can any one help me is resolving issue. I have a vpn tunnel which is up and working.I am using static nat host to host and I want a whole subnet will point to a single IP( which is visible from other side and its part of the VPN tunnel traffic ) can ...
Well the nexus architecture consists of 7000, 5000 and 2000 series in terms of core, aggregation and FEX. So a full proof nexus architecture obviously increase the speed....Can 7k and 5K combined????
Thanks.. If move to Nexus only for 10g connection to servers then I believe 6500 also support 10g card. For SAN we have aggregated gig connection so its not any issue though. internally eigrp and ospf are running. Is there any advantage regarding pow...
thanks vmiller. I have seen couple of links and people have different opinion in this. I am not too much concern about service modules but obviously would like to know in detail what virtualization , power and scalibility features are there and how m...
Thanks for your replyR1 to R2 is a trunk port and the same way R0 to R3 is a trunk port. I want to access from R1 loopback IP 11.1.2.4 to R3 Loopback IP 11.1.2.2.Any help pls.
Core switches are 6509, left two core switches are running with PVST, ciscoios, while right two are with pvst+, catos. There are some layer 3 stacks and layer 2 stacks of access switch.
