Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am trying to understand AAA concept and its use along with CSACS using TACACS+ protocol.As far as I understand, by default there are 3 different privilege levels available (Ref: http://www.cisco.com/en/US/tech/tk59/technologies_tech_note0918...
Hi All,I have 2 Cisco 2811 routers which are connected back to back through 2 modems. In order to understand the time taken for the interface to come up, cable connected to Serial interface has been removed and plugged in again.I have kept continuous...
Hi All, I have two 2801 routers populated with VWIC-2MFT-T1/E1 card in each. I have configured routers using commands as below. controller e1 0/2/0framing no-CRC4clock source internalchannel-group 0 timeslots 1-31 These commands brought a serial inte...
Hi All,I have 2 Cisco 2801 routers each populated with 1 HWIC-2SHDSL card in it. I would like communication to happen between 2 routers using the DSL line (RJ-11 cable).Unfortunately 2 Routers are not able to communicate over the DSL line as of now. ...
Hi All,I am working with 2 ASA 5520 with AIP-SSM-10 installed in both. My goal is to check the failover timer settings so that failover triggers without much delay.While testing failover, source connected to inside interface of firewall is continuous...
Hi Fede,Thank you for your time.The reply was very helpful. I need to read the document in URL yet. So, I will post a reply again after that.Once again thank you for your help.Regards,Nagabhushan
Hi Bhavesh,Thank you very much for your reply.My intention is to minimise the delay after reconnection regardless of time spent before reconnecting the cable, in other words, to minimize the delay of getting a reply or making the link up at minimal a...
Hi, I was trying to fix this problem from past few days, unfortunately with no success. Since I was doing the configuration of T1/E1 for the first time, it took some time. While going through some of the documents, I have read about using RJ-48 cable...
Hi,The output for 'show commands' are attached along with this post. Thank you for the note, which I forgot mention in my initial post that the clock source internal has been configured on only one router.On both routers, under interface serial 'no s...
Hi halijenn,Thank you for your reply.I really appreciate the help from you. It has cleared my doubts. Once again, thank you very much.Regards,Nagabhushan
