Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have issues login in to openconnect using the credentials provided by the Sandbox quick access page. I have tried to tear down the environment and create it again and I still cannot login to the VPN. Environment: Cisco Modeling Labs-20241014T103...
Hi,I would like to monitor "Slip errors" in a e1 interface from my monitoring Central system so I can setup an alarm when slip errors are encountered. It supports Syslog and SNMP.I have been loooking for the SNMP OID objects but I couldn't find the c...
I'm trying to setup a 857W router to get an IP address(DHCP) from my Cable Modem connected in one of the ethernet ports.Not sure if I can do it with this router. Or maybe I am wrong doing the routing part.Can someone help with the issue.Cheers, Juan.
Hi @jokearns1 ,I tried with Anyconnect client and it worked. Once inside the sandbox I noticed the NXOSv is not supported anymore on that CML sandbox and I cannot test my spine&leaf topology. I am currently trying with the CI/CD pipeline sandbox but ...
Regarding my last comment, I can see other labs where we can test NXOSv but with a single node, I'd like to test a complete spine&leaf topology, which I was able to test on the CML sandbox until very recently when NXOSv node support was removed.Than...
I installed ANyconnect secure client and it worked. So the issue must be related with openconnect only. Anyway, I tried to import the lab I exported last week which was a spine & leaf topology with EVPN and it failed to import because the NXOSv was r...
