Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody.I need information abou how ports on 3750 models are shared per ASIC.It would be grate if you provide me with such kind of information for all non-modular switches.Thanks in advnance
Hi, everybodyHow many IPIP tunnel interfaces can I create on Cisco 3750-24TS. Each link will be no more than 128 kb. And how it should be calculated in other cases.Thanks in advance.
Hi,Windows XP VPN Client tries to connect to PIX 506 using L2TP with Certificate and gets error message 678: The remote computer did not respond.ISAKMP: reserved not zero on payload 5! but this message applicable when we use isakmp authe pre-share, h...
Hello,I want to configure PIX to authenticate pptp users with digital certificates using Microsoft Windows 2000 Certificate Server ver.1 and IIS ver. 4.0hostname hostdomain-name domain.comca generate rsa key 512ca identity abcd 10.1.0.2:/certserv/msc...
Hi,I Have two sites with OSPF configured on each.After performing 3Des Encryption between them IA Routes from remote site disappear from the routing table on every router.I want to encrypt all traffic beetwen the networks, so i've configured encrypti...
Hi,No, you don't have to use a router.Just enable IGMP snooping on your switch.For cisco run conf tip igmp snooping command.sh ip igmp groups command will show all existing groups and host connected to theese groupsGood luck
Hi,Do you have any stack port at the rear of these switces? If yes, you can just connecte them by stack cable, and will get one physically separated switch. There will not be any arp problem. If not , you have to configure bond interface to not load ...
Actually, I don't have any error in my application. And 4 sites already working clear over that tunnels . The point is: will it keep working fine on increasing the number of tunnels? is there any formula to calculate that?
