About peter2727

peter2727 · 04-06-2020

Hello Cisco Community -I just encountered this "Interface configured as L2" fault when configuring a new L3Out (routed sub-interfaces).As soon as I unchecked "The Infrastructure VLAN has been enabled on the AEP" under the AEP configuration, the fault...

peter2727 · 02-21-2013

Hello,I was wondering which Guest Operating System people are using for their VSM when installing it on a VM (not using a Nexus 1010).I know the attached picture are the server minimum requirements, but I would like to get a consensus of what most pe...

peter2727 · 01-05-2011

What is the proper way to set bandwidth statements on VTI/GRE tunnels over an MPLS network when different locations have different bandwidth capacities?For example:Location 1 - DS3 - 44mbpsLocation 2 - DS1 - 1.5mbpsWould I put 'bandwidth 1500' on bot...

peter2727 · 04-24-2020

Hello -I do not see "soft-reconfiguration inbound" in the 4.2(x) link you provided. I see the ability to do a "soft" clear on the neighbor, but not a "soft-reconfiguration inbound" so that you can use the "received-routes" command. Example: show bgp ...

peter2727 · 04-03-2020

Hi @RedNectar -Digging up an old thread, but hope you will see this!I just encountered this "Interface configured as L2" fault when configuring a new L3Out.As soon as I unchecked "2. The Infrastructure VLAN has been enabled on the AEP" as you mention...

peter2727 · 04-17-2019

Hello - Thanks for a great explanation. I am wondering something along the same lines as was being originally asked... Is it possible in the ‘destination’ VRF to modify the next-hop so that it no longer points to the PE in the ‘source’ VRF? Essential...

Member Since	‎01-05-2011 08:56 AM
Date Last Visited	‎05-01-2020 12:02 AM
Posts	6

User Statistics

User Activity

Cisco ACI - Interface configured as L2

Guest Operating System for VSM

VTI Tunnel Bandwidth Statements

Re: Cisco ACI configure BGP soft-reconfiguration inbound

Re: "Interface configured as L2"

Re: Route Leaking and Next-Hop