hii have configured windows 2003 server with DNS ,Active directory users and dhcp server. and configured my cisco 1130g AP .i have installed cisco access control server 4.0 because i use LEAP authentication protocol and for the ACS for network c...
hi..i have configured cisco 1130g access point sucessfully and connect it to windows server 2008..there are two network cards in the server to connect internet and access point . all internt data must go through server to authentication purpose ..i...
hii tried to assign ip address to my access point in Lightweight mode using commandAP(config)# interface bvi 1but it doent continue give error "invalid input detected at "' markerplease help..thank you
hiwhen i try to set SSID in my access piont with CLI. with commandAP(config)#interface dot11Radio 0 it is a invalid command.??? i tried several times. what's wrong here????/
thnks fo replyand there is a another issue that when i connect to wifi it ask user name and password ,,but after i provide it wifi try to access and there is failure..is there any issue with active directory?????
and this is for access pointfor coperate servers 192.168.90.15 - ip address of the server machine where acs installed.network access server 192.168.90.19 - ip address of the access point.authentication protocol - LEAPplease help me ...im fed up wit...
