This Document shows us how to add the aIOS AP on to any NMS device what we have - WCS/NCS/PIConfig on the AP==============1>> Configure the Community on the AP with the Community Name With Read/Write (RW) permission2>> Configure the SNMP host IP addr...
IntroductionEnhanced Support for Workgroup BridgesHow to configure WGB with PEAPNetwork TopologyConfigure ACS to Let the WGB authenticate in EAPConfiguring Work Group Bridge (WGB)Install the CA cert on the WGBVerificationTroubleshootingReference Int...
IntroductionSolution Introduction Configuration Guidelines to setup APPLE TV with Cisco Wireless LAN Controller (WLC)Solution Apple TV uses multicast application to communicate between the apple products and needs multicast to be enabled on the wir...
[toc:faq]IntroductionMulticast SniffingSolutionThe controller performs multicasting in two modes:Unicast mode—In this mode, the controller unicasts every multicast packet to every AP associated to the controller. This mode is inefficient but mig...
Hi Kenneth,
do you have an SR opened for this? we suspect a bug, please share SR# with me and attach the file what you have shared here to SR. this will help us to RCA and provide next steps
Regards,Surendra BG
Hi,
the AP is sending Discovery request but not getting a response from the WLC.. Need below debugs + msg logs from the WLC/AP
WLC
Debug mac addr <AP MAC>
debug capwap events enable
debugs capwap errors enable
AP
Debug capwap client event
debug c...
Add your OPNET VNE Server as a trap receiver on the WLC under SNMP settings once added try to poll the way u normally poll from any server to the WLC IP with the OID of the MIbs and it should work fine