Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.
This is command result of "show switch".
Then I did "reload slot 3" and Stack #1 and #3 rebooted unexpectedly.
1 Member 501c.bf9c.1700 1 V03 Ready*2 Active 501c.bf72.8000 10 V03 Ready 3 Standby 501c.bf72.8680 1 V03 Ready
I don't understa...
Hi,
Regarding tftp, I want to "copy tftp:config run" but Error opening tftp....
I set 192.168.0.1/24 on Port1 of C2960, switch1, stand alone and 192.168.0.1 on nic on Computer that launching tftp server. Ping are successful each other.
I tried conn...
Pls tell me how to copy C3850 IOS Software image to tftp.
C3850 default configuration is istallation mode to boot packages.conf.
If it adapt bandle mode, "copy flash:*.bin tftp:command can be conducted to backup. How about installation mode ??
Pls se...
Data transferring speed is clearly much faster in connecting to GE1/0/45 than GE3/0/25.Pls advise me why becoming faster if you know it. Port interfaces Information is very limited as follows. interface GigabitEthernet1/0/45 switchport access vlan 13...
Hi,CIsco 3850, "show vlan rate " command is not found.Could you let me know command to check Vlan Traffic Status and what is percentage of network bandwidth for Vlan ?Thanks
Hi Mark,
I just need how to copy the image file to local computer due to emergency recovery which would happen in the future.
Is the only way to download the IOS-XE .bin file from the Cisco web site ? Never extract it from active switch ?
Thanks,
Hi Jon,Switch is 3850 and Module on the Ports is backup server which backing up data to storage in same subnet. Ethernetchannels, both are same configuration just only different about group name.Taiki
Hi,Exactly, 'Spanning-tree portfast' has port come up faster. How about in steady operation ? Average throughput very fast in backup operation, Is it relavant to 'Spanning-tree portfast' or any other reason?
