Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am currently looking into ways to streamline our workflow when moving from initial detection to full remediation. We have been using Cisco SecureX to try and unify our view across different tools, but I am finding that the pivot into actual threat ...
I have seen this design used successfully. With FlexConnect and local switching, the C9800-CL only needs access interfaces for management and CAPWAP since user traffic stays local on the switches. This is supported as long as you do not rely on centr...
I would first confirm that 172.16.100.254 is actually reachable from the VM and responding on UDP 123. If the 3750 is meant to be the NTP server, it needs a valid system clock and should be running as an authoritative master, otherwise clients may re...
Thanks for sharing this reference. I have seen similar behavior when moving from ISE 3.3 Patch 4 to Patch 8. Patch 4 sometimes caused high authentication latency, which is resolved in Patch 8.
I have dealt with this model before and the issue is that the 3560CG series is end of life. The last supported software was IOS 15.2(4)E, and Cisco no longer makes images publicly available once a platform is retired. Unless you have an active suppor...
It sounds like the loop and AP role confusion happen because the MAP sees the wired switch connection as a potential uplink, conflicting with its wireless backhaul. Make sure the MAP’s Ethernet port is set to bridge mode with VLAN Transparent enabled...
