Hello,
We have at work 1 Catalyst 6509 with 2 SUP720-3B, running 12.2(33)SXJ9 and a FWSM card with a 4.1(15) firmware version.
My problem is that the cpu of our 6509 Route Processor is at ~65% with like 30-35% of interrupts for quite some time.Using ...
Hello,We have at work 1 Catalyst 6509 with 2 SUP720-3B configured for SSO and running quite an old ios image: 12.2(18)SXF7.Last week the standby sup took over the active one, because of a parity error but that's not really the main problem. Since the...
Hello,Just a quick question as i did not find any document related to this function on fwsm, is wccp supported on the fwsm and if yes since which version ?My versionFWSM: 4.1(3)ASDM: 6.2(2)FThanks in advance.Regards,
Hi all,I have a quite strange VPN architecture included and i have some problems that i am not able to resolve:- I use the ssl vpn gateway to allocate internal IP adresses of the local network described in the diagramm (network 8.8.2.0 or 8.8.3.0 dep...
Hi all,I'm trying to set up an SSL VPN (not clientless) with a cisco ASA 5510, but i am a little blocked since for tests the vpn will be in the same subnet as the destination to reach and therefore there will be only one interfaces connected to the n...
After some more testing, I found why.
My vlan interconnecting the MSFC and the FWSM was configured like below:
interface Vlan660
description FWSM
ip address 172.29.30.114 255.255.255.252
no ip redirects
ip flow ingress
ip verify unicast source...
Well, yeah i agree for this workaround but with this type of architecture (quite a odd one in fact), this is the best that you two helped us to find.For the single acl and the single class map, i will try this tomorrow if i have some free time (its 1...
Yes in fact, i was relying on my memory to rewrite the log message, so it was only a part of this message.A tunneled route did the job, i wrote:access-list tcp_bypass2 extended permit tcp 8.8.2.0 255.255.255.0 8.8.3.0 255.255.255.0access-list tcp_byp...
Thanks for your help !I did some tests on your workaround, but i can't apply this command and i don't quite understand how to apply it. The cisco doc is a little confusing since there is two ASA to config, and it is not precised if on this example, t...
