Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Long shot. SCT RTK-AM1 question. Cisco EQ room. All gear behind the display. TX at the table. Navi running through the SCT like its supposed to. 2M USB-C at the TX to the laptop. 1M USB-C at RX to EQ. Picture blips every 12 seconds. Just a quick blip...
Client is asking if we can route their laptop (main/extended) from their dock to the dual displays while in a call. Essentially not viewing far side content or people. Which to me is just an audio only call, no content sharing in either direction. I...
Hello, I have an request to use the USB-C at the table to do main and extended on the 2 displays connected to the EQ. This is as in using the room as presentation only, not in a call. Right now we are using the Atlona AT-OME-MS42 with great success ...
Fixed the issue. The issue was Panduit Netkey keystones. I terminated to male RJ45's and even used a female coupler in place of the keystones and we are in business. FWIW, we only do 1080P for content and are on CAT6. Less than 40M per the manual.
6A is recommended only due to length. We are using 6 and well within 40M. We also only allow 1080P for content. Turned out to be the Panduit Netkey keystones provided by others.
You are on separate networks. Your easiest solution is to put a small POE+ unmanaged switch off one of the ports of the EQ. This will allow the most reliable solution for years to come. Connecting to the managed network WILL fail. Not if, but when.. ...
I keep seeing "default config" however I'm the AV integrator and they get provisioned by the companies IT department themselves. So when they get to me, they've already run their script which changes all the settings their way. So I have no way of k...
The Liteware product is on the way. However I'm not sure what its going to do differently than a dock. I have successfully achieved the goal by changing the monitors from 1 to auto. That was the setting I was missing this whole time. I you can easily...
