Is it possible to connect a spa535g2 phone via SSLVPN to a sa520w endpoint? I have sslvpn configured on my sa520 and pc's can connect to the sslvpn without issue, but my phones cannot. Error states: Failed to obtain Webvpn cookie Can this phone only connect to a uc500.? Is there something different I must do? Thanks. Sent from Cisco Technical Support iPad App ... View more

I need some help with configuring Dynamic PAT (I think). Here is my setup: -Cisco UC520 runing latest software pack. -Configuration done using CCA -Block of 5 Public IP addresses -2 Internal webservers on port 80 -UC500 Internal IP 192.168.10.1 -UC500 External IP 70.91.24.41 -Both internal webserver have their gateway set as 192.168.10.1 I would like to have inbound traffic fowarded internally in this way: External IP 70.91.24.42 port 80 -----> Internal 192.168.10.6 port 80 (Webserver1) External IP 70.91.24.43 port 80 -----> Internal 192.168.10.16 port 80 (Webserver2) I believe this is called Dynamic PAT..? Can this be done? Do I need to to use NAT pools or something? And can it be condfigured using CCA so that I conform to out-of-band configuration? I'm just confused on how outside clients would be able to successfully NAT if they get directed to the UC500 using IP address 70.91.24.41 but then the NAT translation changes it to 70.91.24.42 and the traffic is sent back to the clients with that IP. Wouldn't that get rejected on the client's end? Hope I'm making sense here. Thank! -Brian ... View more

Hello, We have a UC520 installed in our network. Data VLan: 192.168.10.x Voice VLan: 10.1.10.x Phones are working just fine. We are trying to implement an imaging server on our data VLan that runs TFTP. The problem is, is that the TFTP service on the imaging server won't start because it see an existing TFTP server (UC520) on the subnet. I'm confused though because doesn't the TFTP server on the UC520 only broadcast itself on the Voice VLan? If not, is there any way to modify the config to make it do so? Thanks. Brian ... View more

Hello, I've gone through the setup instructions for configuring a jabber iOS client with my UC520. I've successfully configured 2 phones with the jabber client that work great when connected to the local WiFi. I've also been able to get the 2 phones to register over 3G with the Cisco AnyConnect VPN app as well. However, when I go to place a call, I immediately get a busy signal. How can I troubleshoot this? Thanks. -Brian ... View more

I have a user who's physical desk has all been assigned to an additional 2 other people.So they are all sharing one phone now and I am attempting to configure extension mobility on that phone for all the users. The 2 new employees are easily added as new user profiles in the extension mobility tabs. However, the existing user is already setup as a standard user with a 7960 phone. If I enable extension mobility to her existing phone, it wants to wipe out her existing user/vm account. Can this be avoided? I do not want this user to lose their mailbox etc... Thanks,. -Brian ... View more

I am setting up a 7960 phone for extension mobility. I would like to add a dialable intercom button to the phone profile for when no one is logged in and to the user profiles for each repective user. However, if I change the amount of button to 2 and try to set button 2 to diable intercom, I am unable to do that. The only option for any of the buttona is normal or shared. Is this doable? Please advise. -Brian ... View more