Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have two sites each with a UC520 – HQ and Branch. Can they be set up so the HQ has SIP to our Telco provider for PSTN access and the branch uses the SIP connection from the HQ over IPSec?Also our CEO needs a phone at the branch with his HQ e...
Hello, I have two sites each with a T1 line, 1721 router, and a uc520. Each location has 8 users. We can extension dial each location via what I assume is a VPN Tunnel.My boss would like 7940 phone at home.Is this possible?Would we need another 1721 ...
It works now, thanks John!Branch:dial-peer voice 2102 voip description outbound call to local through HQ destination-pattern 91[2-9]..[2-9]...... session target ipv4:10.1.102.20 dtmf-relay h245-alphanumeric codec g711ulaw fax protocol cisco no vadHQ:...
I changed the remote site dial peer to the following:dial-peer voice 2102 voipcorlist outgoing call-localdescription outbound call to local through 30destination-pattern 9[2-9]......session target ipv4:10.1.102.20dtmf-relay h245-alphanumericcodec g71...
Hi John,I have site to site extension dialing working. Next I would like to configure the branch to place all calls through the HQ site.Site to Site config:HQ:voice translation-rule 1112rule 1 /^9/ //!voice translation-rule 1114rule 1 /^01\(....\)/ /...
Hi John,I am not clear on the difference between using TEHO/LCR or using a dial-peer at the HQ pointing to the branch?I like the idea of the blast group at the HQ but this poses some problems with voicemail and outbound calls:Is there a way to make t...
Hello Marcos,I have a question about site connections.I have two office locations (T1) and one home (cable modem). UC520 8 users license, and SPA525G. Currently the sites are connected but the config was done by someone else. When I use CCA 2.2.2 and...
