Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have a requirement to provide VOIP recording using SPAN sessions on a NX 5548.Can someone confirm please whether a VLAN can be used as a source in multiple SPAN sessions on a 5548 ?I.e. monitor session 1 – source vlan AA, dest port Xmonitor sessio...
Have an issue trying to get IOS to NAT both src and dst addresses.It looks like traffic is being NAT'ed ok going from outside to in and i can see a reponse packet coming into the inside interface on the NAT router but it gets lost and never makes it ...
Hi,i have a customer that wishes to use a CSS11501 with 2 web servers, 1 active and 1 standby.the primary sorryserver content option seems to achieve this, however the customer wants content requests to go to the sorryserver even after the primary se...
I have a customer who wishes to use CSS to front end web servers and have the CSS perform SSL offload- straightforwardHowever the application may need client authentication - ie client certs.The config guide shows that this can be done on the CSS but...
Hi,Is it possible to use the css to load balance for OWA and offload SSL ?have tried this and it appears to break OWA even though other web apps work ok through same CSS.When removing ssl termination could only make load balancing work when incoming ...
ok i had hoped this was not the case as another post seemed to suggest physical ports could be used more than once in SPAN sessions..seehttps://supportforums.cisco.com/message/3369370#3369370
folks,many thanks for the replies...tried both.The NVI did not help but putting a static host route into the config achieved the desired result.Interestingly there is also an option to do this on the outside source static command .........add-routeI...
thanks for the reply.i saw reference to those persistence commands in another post and i think they would help but not completely solve the issue.Ie in flight connections would stay on the sorryserver but new ones go the available primary server.The ...
ok tks for the reply - i think i came to the same conclusion that for client authentication to work a CA cert needs to be installed in the CSS. So a CA needs to generate the client cert and a CA cert be installed in the CSS. The CA could be a public...
