Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to poll for dynamic MAC table from the switch now i am stuck as none of my 3750s cant snmpwalk the .1.3.6.1.2.1.17.4.3.1.1 aka
dot1dTpFdbAddress
snmpwalk -v2c -c public 10.60.128.4 dot1dTpFdbAddressDid not find 'zeroDotZero' in module...
HI guys,I have a DS3 line with two cisco 3925 ISRs on both ends of the private line. I need to create a QOS to allow any lync traffic ( that is marked with dscp of 26) to go with highest priority and always to have sufficient bandwidth over this 42me...
Hi,I need to introduce a TMG inside one of our branches networks so the default internet traffic pass through TMG and then to the ASA as per the new standard. I am new to TMG and playing with few designs on how to set TMG up as painless as possib...
Hi Guys, facing an issue here and need some expert knowhow....I have several interfaces on my ASA that is also connected with S2S to the HQ office...i have 3 /24 subnets heavily subneted inbetween interfaces and have a collapsed core as well so any...
siteA 10.10.10.1/24 ----s2s----- siteB 12.10.10.1/24how do i control an incomming traffic from a remote site (ipsec site to site) as in how to block certain services/ip addresses ad so on ? i tried to track to see what is the interface the encrypte...
i know that what ever traffic that is going to need to reach my users will have to pass throught TMG if i dont have PBR on my CSW, and i need Manangement int on ASA justfor that .. to manage it but what i encountered was that people comming from ...
thats where the problem lies...i have to have Y and Z vlans routed by ASA (secure segments) and ASA has to have a leg ( sub int) in X vlan as if i need to bypass TMG to staticaly route and staticaly NAT directly to servers in X vlan....so i am ti...
hmm i thought on new ASAs above 8.3 NAT comes first... and if so then the ACL on the outside wont see the external IP...also how will that make my LAN users use the external IP addresses and not just intervlan ?
