Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Im looking for a way to do thishttp://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_configuration_example09186a0080094715.shtmlOnly I need to do it in Unity Express. Any Ideas?
I have had an unusual amount of failures on some cp-7941G sets. The Hook switch starts to not function properly after a short time (couple of months). I have had three in just the last week. These phones were located in either a warehouse or guard sh...
You can also use this Valcom V-9940 and a Small Valcom power supply.http://www.valcom.com/v-9940.htmIt will connect by FXS or FXO port and will give you a 600 or 8 ohm output.It also supports loop supervision.
You can change the number using the calling number transform mask. However that will change it for all calls. You will also have to change it to another DID. I too would like to know how to show Unknow/Private. Especially on a call by call basis.Does...
