Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Given that I have same topology as shown in Internet Edge Cisco IPS Design Best Practices and basically inserting 4270 Appliance into an INLINE mode. Core and Distribution Switch = Layer-3 routed linksDistribution Switch and ASA = Layer-2 access po...
If having a single /24 allocated address space, can i split this into smaller subnets so that half of the subnet preferred to ISP1 and half to ISP2 as the primary path respectively? and should there will be link failure, convergence routes via iBGP p...
The situation is that - I'm wanting to implement a "Do not Save File Locally in their Hard Drive" or "Do Not Print" Policy in an end-host PC with CSA agent enabled device. It is relevant to the built-in "Blocked Writing Files to a USB or External dri...
A scenario of DMVPN Hub and Spoke. Hub is in HQ Corporate whileSpokes are Internet-Based only. Any idea how could I establish peering relationship if the Spokes are Dynamic IP address assigned? it should learned via NHRP?I'm wondering how Zero-Touch ...
Hi there,Does Nexus 5500 series require a Nexus 7000 parent device? or it will be supported with Catalyst 6509?If this is the scenario :CAT6509 - Core Layer 3CAT6509 - Distribution Layer 2/3NX-5548 - Access Layer 2And FYI, no VSS on Catalyst 6509.Tha...
Try this .. you may need to learn your Inside Prefs..either manual or dynamic method. Dynamic: oer master learn inside bgp no aggregation-type bgp oer-map cisco 1 match oer learn insideManual: oer master policy-...
based on your Logs and config, i see that your mode route is "OBSERVE". Change it to "mode route control" oer master mode route controlHTH.Thanks-Gerard
