Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I have a problem with my IW9167E access point running the WGB software. The AP is connected to a switchport configured as trunk, and behind the switch I have 2 VLANs:1x VLAN for management1x VLAN for trafficThe AP and the switch both h...
Yes sure,You don't have to boot the AP in URWB mode, but in CAPWAP mode. If you boot it into URWB mode, it will not join the controller. Put it in CAPWAP mode, then make sure it is joined to the controller, and also make sure your controller version ...
Hi @ashwith-c ,Most probably the SSID is not broadcasting because the AP has not joined the WLC over the URWB link. To check if this is the case, unplug the wired cable that connects your ap to the wlc, and establish the URWB link and see if it will ...
Hello Sorry, but this is wrong. If the AP is set to boot in URWB mode, it will not join the controller. You have to boot it in Capwap mode (configure boot mode capwap), and then do the configuration accordingly from the WLC.
Hi @Cristian Matei ,I am always attached over wired, and within another VLAN. However, connectivity between VLANs is working. I can ping other clients in the same VLAN as the APs.Strange thing happened yesterday, what I do when I leave the site is th...
