Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I have a problem with my IW9167E access point running the WGB software. The AP is connected to a switchport configured as trunk, and behind the switch I have 2 VLANs:1x VLAN for management1x VLAN for trafficThe AP and the switch both h...
Hi @dijeshkeloth ,I am sorry to tell you, but I encountered this problem in my deployment, and it was a nightmare for me. When using UNII-2 extended frequency band, DFS (Dynamic Frequency Selection) is enabled by default and you cannot turn it off, a...
Okay, so in this case your problem is not with the DHCP itself, it is with the wireless link.Did you do proper alignment for the antennas on both sides of the link? What RSSI values are you getting?
Hi,If you mean which radio on the access point, it depends on your configuration. In your case, you will be using 2x2 MIMO, so radio1 and radio2 can be used, which map to ports 3,4 or 5,6 depending on which radio you are using. Again check the 5GHz s...
