Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Im having an issue with getting an ospf summary address appearing in a routing table of an ASBR.
Topology is:
(BGP-NETWORK)-(WAN-RTR)--(ASBR)--(OSPFNETWORK)
I am trying to summarize the 10.0.0.0/8 network on the ASBR so I can export a 10/8 s...
Hi,
I'm studying for the CCDP exam and I am taking in alot of new concepts, I have started looking into fabircpath but this seems like its going to be a non-starter when compared with technologies such as VXLAN with the MP-BGP-EVN control plane - e...
Hi,
I have 2 controllers (5508's) one acting as foreign one acting as anchor, I want to create a guest wired LAN but have Cisco ISE handle the CWA.
I have created the guest-lan, bound it to a vlan and have trunked the VLAN to my swicthport. guest a...
Hi,
Are we able to create wildcard entries in the MAB in ISE 2.0 for devices that do not support 802.1x
We have a large number of Mitel phones - (I am unsure if we can place certificates onto these) are we not able to just allow all mitel devices ...
Hi I have ISE 2.0 and I am trying to create a auth rule to allow access to a certain SSID if the AUP was accepted less than 3 hours ago.
However when I try and create the rule with the condition ENDPONT:LASTAUPACCEPT LESS 3 - I get the error 'Could ...
Hi guys
Thanks for the responses but I have found the solution
I am going to issue a bgp aggregate address from the wan router summarising the ospf range - this removes the need for the ospf summary
Hi,
I want to summerize my ospf into BGP.
I am recieving ospf routes in the 10.x.x.x range as shown :-
Gateway of last resort is not set
192.177.58.0/32 is subnetted, 1 subnetsB 192.177.58.9 [20/0] via 192.168.10.2, 00:19:54C 192.168.10.0/24 is d...
sorry to drag up this old topic but i am having something very similar
please see my post
https://supportforums.cisco.com/discussion/13213831/wired-guest-lan-cwa-cisco-ise
can anyone assist??
I have performed a capture on a client, I can see 2 way transport between ISE and the client, so the WLC must been pusing the client towards ISE but still getting the browser timeout
