Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi bit of a newbie here,
We have just deployed Cisco Prime Infrastructure 3.1.2 in place of our old Cisco WCS.
All is working fine as far as managing our 50 or so controllers and their configs but I can not work out how to push firmware updates out t...
Hi we recently updated all of our WLC's to 7.098 and it all went smoothly, controllers rebooted and AP's updated their firmware and rebooted OK.One WLC (4402) which was working fine since the update now has no AP's associated. The AP's were all confi...
Hi,We have several WLC's in school sites all connected back to a central WCS (ver6) which is working fine so I am just trying to clear up a few small issues.At a couple of sites I am getting alarms on WCS as per example below which has me at a loss.W...
Hi,We are running WCS Version 6.0.181.0 and had a 5508 WLC fail that was connected to this WCS. The WLC was replaced and is running the same config and Software Version 6.0.196.0.In WCS the ol...
Hi guys, sorry to hijack your thread but how did you run this command? I can log into the console of the appliance as admin but get very limited access???
Thanks
Thank you again Nicolas,Upon further checking it turned out to be an IP conflict with the 2nd AP-Manager address. We had another device installed in our core infrastructure and some one assumed that the WLC only had one IP.All fixed and working perfe...
