Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a working 1200 Access Point, that uses 802.1x PEAP authentication back to an ACS. I want to enable 802.1x on the switch interface the AP connects to, Interface f0/2dot1x port-control autodot1x multiple-hostsWhen enabled the dot1x stays unauth...
We have setup a site to connect to the ASA with ezvpn and nem, which works fine, but we also want internet based traffic to be in the tunnel then go out through the asa. This means that it arrives encrypted on the same interface as we want to send it...
