Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'v successed to open webserver to public internet by following command on ASA5510.access-list DMZ_nat_static extended permit tcp host 192.168.10.210 eq www anystatic (DMZ,pppoe) tcp 200.200.200.10 www access-list DMZ_nat_staticI can connect [Web ...
Hi,https://supportforums.cisco.com/message/3255901The thread has been resolved by teacher Naman.But DMVPN session is always disconnected per several minutes.If I throw PING command, the session is reconnected soon.What is the cause of this? Rekey or ...
Hi, everyone.The main site having DMVPN-Hub-router is provided only one public IP by ISP with PPPoE.I am running dmvpn between three points with no problem.Now I am trying to insert ASA5510 between internet and dmvpn-hub-router.■Then what should I do...
Hi,What is the best practice for DMVPN(IOS12.4) on ASA5510.■Design 1Placing dmvpn hub router behind ASA.Q: In this case, does ASA have to configure NAT traversal, UDP encapsulation, and so on ?■Design 2Placing ASA behind dmvpn hub router.Q: How are t...
Hi,What is the best practice for DMVPN(IOS12.4) on ASA5510.■Design 1Placing dmvpn hub router behind ASA.Q: In this case, does ASA have to configure NAT traversal, UDP encapsulation, and so on ?■Design 2Placing ASA behind dmvpn hub router.Q: How are t...
Hi, Jennifer.Thank you for your reply!3) Enable "inspect pptp" on your global_policy policy-map.⇒ Could you tell me sample command about this?Regards,okumura
Hi,Thank you Naman.> Do the OSPF neighbors also go down ?I think it does not go down.■DMVPN HUB ROUTERDMVPN_HUB#show ip ospf neighborNeighbor ID Pri State Dead Time Address Interface192.168.1.1 0 FULL/DROTHER 00:0...
